This month’s demonstration was performed by Matthew Walker. Matthew worked on a collected Sierra juniper. The yamadori material had been collected three years prior. Matthew shared that these Sierra junipers are found at elevations between 6800’ and 8200’. The tree was presently in a plastic bonsai training pot planted in three equal parts Akadama, pumice and lava rock. Showing its signature blue, green, gray foliage, it was ready for its first styling. The original starting size of the tree was one hand lifting Katade-mochi size approximately 14” wide and 10” tall. The interesting and powerful material was at one point attached to a larger tree. As the styling progressed, the completed tree ended up more compact; ending up in the Komano small size approximately 9” in diameter and 10” tall. As with the first styling of most trees the challenge of finding the front and angle of the tree presented a few options. With ample dead wood and live life lines from the 3” trunk and slightly wider nebari to the curved 4” Y above, the front highlighting theses desirable attributes was determined.
The next decision to be made was the form of a somewhat larger 8” long primary branch curving away from the main trunk and extending parallel about 6” above the soil line. This branch would prove to be a challenge since its connection to the Y and main trunk was showing signs of splitting and being too thick to bend. The verdict was to reduce its length and to jin the branch to approximately 4”. Matthew pointed out that the base of jin should have angles and taper which gives it a more natural look as opposed to a symmetrical ring where it meets the remaining bark. He also mentioned that a torch is a good way to remove smaller splinters and hair like fragments. A wet towel is essential to cover and protect the other parts of the tree while doing so.
As wiring commenced, starting on the lower secondary branches, the yamadori material began to reveal its bonsai identity. Matthew gave many valuable tips on wire bending specifically with how the wire should be wrapped into a slight hook at the end of each limb in order to keep it in place and at the desired direction. Foliage pads were craftfully created with the tips longer than side branches creating five to six tapered fans extending from the gracefully curved trunk.
Matthew reminded us that the apex of bonsai trees can be the most difficult and time-consuming aspect to styling. Referring this part of the creation as the “comb over”, an apex may be made of two or more small branches and compacted for density.
The elegant yet rugged bonsai tree was completed by being placed in its new appropriate angle with its training pot placed in a three-gallon plastic nursery pot at about 45 degrees.
Photos by Diane Matzen